橡胶止水带注意事项
Precautions for rubber waterstops
1.止水条通常安装在建筑物给排水、隧道、路面等处，混凝土浇筑前，应根据具体位置安装止水条。
1. Waterstops are usually installed in building water supply and drainage, tunnels, road surfaces, etc. Before pouring concrete, waterstops should be installed according to specific locations.
2.确定止水带的安装位置后，在止水带页和底部涂上一层粘合剂，待胶水蒸发一段时间后粘贴。它也可以用钉子、螺栓或铁丝固定。同时，应预留一定的凹槽，以便于止水带在水膨胀后有足够的空间延伸。
After determining the installation position of the waterstop, apply a layer of adhesive to the waterstop page and bottom, and wait for the adhesive to evaporate for a period of time before pasting. It can also be fixed with nails, bolts, or wire. At the same time, a certain groove should be reserved to facilitate the extension of the waterstop after water expansion.
3.如果混凝土页面湿冷或不均匀，粘合剂粘附固定不牢固，可根据实际情况用高强度钉进一步加固。需要注意的是，止水带必须与混凝土界面紧密接触，固定牢固，以避免止水带从页面上脱落，失去防渗效果。
3. If the concrete page is damp or uneven, and the adhesive adhesion is not firm, high-strength nails can be used for further reinforcement according to the actual situation. It should be noted that the waterstop must be in close contact with the concrete interface and firmly fixed to prevent it from falling off the page and losing its anti-seepage effect.
4.由于止水带的应用可以延伸，因此可以在接口处采用重叠的方法进行搭接连接。搭接外粘贴后，用高强度钉固定。安装路径沿沉降缝产生一个闭环，其中不能留有断点。
4. As the application of waterstops can be extended, overlapping connection can be used at the interface. After overlapping and pasting, fix it with high-strength nails. The installation path creates a closed loop along the settlement joint, without leaving any breakpoints.
5.止水条定位安装完毕后，应将止水条浇筑成混凝土包装袋，包装袋的厚度应大于50。mm。浇筑混凝土时，应避免工具接触止水条。
After the positioning and installation of the waterstop is completed, the waterstop should be poured into a concrete packaging bag, and the thickness of the packaging bag should be greater than 50. mm。 When pouring concrete, tools should be avoided from touching the waterstop.
6.在固定止水条的缝隙中，需州苗木 保定通风管道 丝网立柱模具 尼龙输送带 保定空压机 高碑店养老院要对地面专用胶进行灌溉，还必须保持路面干燥、整平，无杂物或灰尘。
6. In the gap of the fixed waterstop, it is necessary to irrigate the ground with special adhesive, and it is also necessary to keep the road surface dry, level, and free of debris or dust.