带式输送机托辊设备故障的解决办 1、运转进程托辊轴承坏死 , 与胶带硬性冲突过热加快老化, 严峻的可致使胶带焚毁。 1, the operation process of roller bearing necrosis, conflict with tape hard overheating accelerate ageing, serious can cause tape burned down. 形成这一表象的首要原因: 托辊轴承质量不高 , 光滑功能差; 为防止因托辊质量影响胶带运转事端的发作, 采纳定时或不定时替换托辊等办法 , 确保设备和出产的正常进行。别的, 可对于托辊运转质量和稳定性与出产厂家进行联合研讨攻关 , 不断提高托辊产品质量。胶带巡视力度不行, 职责追查准则执行不到位; 加强胶带沿线设备的巡视力度, 特别是长距离胶带设备的巡视工刁难削减胶带机运转事端发作具有极其重要的现实意义。 To form a representation of the primary reasons: roller bearing quality is not high, smooth function is poor; To prevent disturbance for roller quality influence tape operation seizures, adopt the way such as regular or not regular replacement roller, to ensure that the equipment and produce of rails. Other, quality and stability and can run for roller production manufacturer for joint research, continuously improve product quality of roller. Not tape strength of patrol, responsibility tracing code execution does not reach the designated position; Strengthen the equipment patrol along the tape, especially long-distance tape equipment patrol versed in spite of cut tape machine running disturbance attack has extremely important practical significance. 2、运转进程中托辊掉落 , 被回程胶带卷至滚筒形成胶带破穿或撕裂 , 这种毛病后果严峻, 经济损失大。尤其是没有卡槽的托辊, 轴端面与支架外外表平齐, 若是支架支撑强度差, 在轰动等外力效果下支架变形, 托辊很容易掉落。 2, roller, in the process of operation by return tape roll to roll forming tape broken wear or tear, this kind of problem serious consequences, big economic loss. Especially there is no card slot roller, shaft end face flush and stent appearance, if the bracket support intensity difference, stent deformation under the external force such as sensation effect, roller is easy to fall off. 可在托辊轴端面钻孔攻丝, 然后用螺栓固定一块眼板, 能够起到卡槽的效果。 Can be in